RTcom Radio Modems Manual de usuario Pagina 55

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 117
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 54
Page 55
501 SE Columbia Shores Boulevard, Suite 500, Vancouver, Washington 98661, USA l +1 360 859 1780
SmartRG Inc. Propriety and Condential. All Rights Reserved. Copyright © 2014 smartrg.com
Field Name Description
Classication Name A free form text eld. Enter a descriptive name for this rule.
Rule Order [Last, Null] Select Last to set this rule as the very last classication rule to be processed.
Select Null to set this rule as the next classication rule to be processed within the exist-
ing list of classication rules.
Rule Status [Enable, Disable] Select whether this rule is active or turned off.
Class Interface [local, eth0..eth4, wl0] Select an interface.
Ether Type [IP, ARP, IPV6] Select the Ethernet interface type for this classication.
Source MAC Address
Source MAC Mask
Enter the source MAC Address and Source MAC Mask applied to classication.
Destination MAC Address
Destination MAC Mask
Enter the destination MAC Address and destination MAC Mask applied to classication.
Source IP Address/Mask Enter the source IP Address and Source IP Mask applied to classication.
Destination IP Address /Mask Enter the source IP Address and Source IP Mask applied to classication.
Protocol (Optional) Enter the Protocol specied for classication criteria.
UDP/TCP Source Port (Optional) Enter the Source Port applicable for classication criteria. Expressed as a range
or single port. (port:port or port).
UDP/TCP Destination Port (Optional) Enter the Destination Port applicable for classication criteria. Expressed as a
range or single port. (port:port or port).
Specify Class Queue Choose from available queues in the drop-down list.
Packets classied into a queue that exit through an interface for which a queue is not
specied to exist, will instead egress to the default queue on the interface.
Mark Applied Differentiated Service
Code Point
Select the desired DSCP code from the drop down list.
802.1P priority [1-7] (Lower values have higher priority.) This value is inserted into the Ethernet frame to
be used by QoS disciplines to differentiate trac.
Rate Limit (kbps) Data trac rate limit applied to classication.
The individual elds on this screen are dened as follows:
Vista de pagina 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 116 117

Comentarios a estos manuales

Sin comentarios